Water and Sacred Geometry

This is a short video presented by Gregg Braden. While the man himself is certainly questionable, some of his demonstrations were extremely thought provoking. With the surge of new members ATS has had recently, I thought it was worth reposting. There is already a wealth of information on this website if you’re interested.

I’m going for the “food for thought” approach and I’m not here to prove or dispel of anything’s existence or effectiveness. My mind was blown starting at the 2:00 minute mark.

The average adult human comes in around 65% water and about 73% for a newborn baby. So I thought, could we possibly manipulate the water inside our own bodies to heal or achieve a desired result?


Studies conducted in 1992 by Tainio Technology, as an independent division of Eastern State University in Cheny, Washington, reinforce the findings of these earlier researchers. Tainio and colleagues determined that when a person’s frequency drops below the optimum healthy range, the immune system is compromised.

Human Body:

Genius Brain Frequency 80-82 MHz
Brain Frequency Range 72-90 MHz
Normal Brain Frequency 72 MHz
Human Body 62-78 MHz
Human Body: from Neck up 72-78 MHz
Human Body: from Neck down 60-68 MHz Thyroid and Parathyroid glands are 62-68 MHz
Thymus Gland is 65-68 MHz
Heart is 67-70 MHz
Lungs are 58-65 MHz
Liver is 55-60 MHz
Pancreas is 60-80 MHz

Sickness:

Colds and Flu start at: 57-60 MHz
Disease starts at: 58 MHz
Candida overgrowth starts at: 55 MHz
Receptive to Epstein Barr at: 52 MHz
Receptive to Cancer at: 42 MHz
Death begins at: 25 MHz

Food:

Fresh Foods 20-27 Hz
Fresh Herbs 20-27 Hz
Dried Foods 15-22 Hz
Dried Herbs 15-22 Hz
Processed/Canned Food 0 HZ

Note: Fresh foods and herbs will have a higher frequency if grown organically and eaten freshly picked.

The BT3™ Frequency Monitoring System


During his work with plants, soil, and water in his agricultural projects, Bruce Tainio of Tainio Technology invented and built a machine called a BT3 Frequency Monitoring System. This device – modified and perfected over the years – used a highly sensitive sensor to measure bio-electrical frequencies of plant nutrients and essential oils.


The BT3™ frequency monitoring System has a one of a kind sensor that can be used to measure the frequency of any substance or object. When measuring plants, the frequency of the healthier, more nutritionally balanced plant will always have a higher frequency than the less healthy one.

In working with rock powders for agricultural application, we choose certain combinations based on their frequency readings. We then send samples to a laboratory for a mineral analysis to confirm our findings, and our choices have always turned out to be the best mineral combinations.

Frequencies of an individual can be measured also. You can determine where an energy block or leak is occurring in the body by reading the frequency levels. Where there is an energy leak the reading will spike. For example, in the case of a back injury, the meter will show an energy spike at the injured vertebra. If a person isn’t feeling well, his or her brain energy reading will be lower than it would normally be if well rested and in good health. You can check specific organs by placing the sensor on that area. If the organ is not functioning properly, the frequency will be significantly lower than the other organs.* You can even tell whether a person is functioning in a right brain or left brain mode. We have used the meter to test foods and supplements. Generally speaking, a higher energy reading indicates that it is a nutritionally beneficial food. Highly processed foods will show very low frequency readings compared to fresh fruits or vegetables, for example.

The meter’s applications are limited only by one’s imagination. The best way to use it is in comparison studies, comparing one product with another, or taking before and after measurements. What makes this frequency meter unique is it’s extremely sensitive sensor.

Because of its high sensitivity, background interference will usually have to be taken into account. It does take some practice and patience at first. It is easier to use if you find a place in your home, laboratory or office that has as little electromagnetic interference as possible, then always use your meter in that area if you can. The meter may not give you a zero reading to start with; but a room with minimal interference from radios, computers, etc. is better because you can establish a base line to work with.

I’d like to know your opinion on this topic and I’m interested in further reading. I will continue to support the idea that frequency and health are related, but also open to the potential of it falling short. In today’s world, I feel as though it’s being used against us as a silent weapon and I’d like to know how to fight back. Any thoughts?

Link to Thread :  http://www.abovetopsecret.com/forum/thread1061295/pg1

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: